Tensioners are expensive (more than this $179 saw) so eyeballing the blade deflection will suffice at this level. Band saw blade tensioning is a mysterious process for some reason. You adjust the blade tension using the top knob. To set the blade tension on the Ryobi BS904G 9-inch band saw, first close the cabinet doors. All aluminum wheels and ball bearing supports.Blade-tracking sight window for greater accuracy.The process is really pretty simple, even for a first-time user. Then, spin the lower wheel by hand while using the tracking knob to get the blade centered. You can fine-tune the blade tracking with an adjustment knob also located on the back of the saw.Įven if your blade tracking is a little off at this point, raise the lever to raise the top wheel. Simply feed the blade of the Ryobi BS904G band saw through the blade guide assembly and around the wheels and shift the blade in the center of the wheels. You’ll need to lower the lever on the back of the saw to lower the top wheel. Inside the cabinet are two aluminum wheels and ball-bearing supports. The saw’s two-door cabinet opens up without tools. In particular, I’m referring to the blade and the table. There are only a few pieces to assemble on the Ryobi BS904G, but they are critical.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |